[madmanan]

this is great! thanks!

i do have one place where i am a bit confused though, i didnt understand exactly which way the sensor slides out of the handle, from the shape of both it would seem it slides out from the non-hinge end of the handle. although i wasnt sure what you meant by "prise"?

if that is correct, when you slide the new sensor back in, do you do so wires first from the non-hinge end of the handle?

thanks!

 

[madmanan]

I hope these pics help to explain what I was meaning.

When putting the sensor back in put wire in first from the end nearest where the blank part was.


Prise small screw driver where#1 is to remove the sensor it's just to release the tabs on either side of it as per pic above with the arrow.

that helps a lot! thank you again! great guide, sorry i got a little confused