[Dave Kwatro]

Good tip for cleaning the steering wheel, I want to get the stitching back to pure white rather than slightly grubby.

Here's my diffuser I made in my garage

 

[Dave Kwatro]

PS, you can leave the little philips screws out, I did. I used a plastic trim tool and prised along the top of the diffuser to remove it. Once it's removed, removing it again is easier.

Also one of the screw lug thingies that are clipped into the wheel well underneath broke and kept spinning, so glued a new one in. If anyone if removing the diffuser, be careful of these and if stiff, remove spare wheel and try and hold these plastic bits to stop them twisting.

 

[Dave Kwatro]

Hi there guys, have your diffusers stayed put? I recently got one like this from eBay but unfortunately didn’t come with holes to fit the screws in. Worried that it might fall off when I’m driving.. any issues or ways around it? Thanks

I would say, you need the 3 screws underneath because if the wind catches it whilst driving at high speeds, it probably will pull it off!