Audi A5 Forum & Audi S5 Forum banner
1 - 9 of 15 Posts

· Registered
Audi A5 Coupe 1.8 TFSI 2012 Facelift
Joined
·
30 Posts
Discussion Starter · #1 ·
I'm retrofitting the RS5 spoiler on my A5, and everything is done except the wiring. I don't want to buy the wiring harness because it's a bit expensive (120€ with shipping to my location), so I decided to make the wiring by myself. I have the scheme and the connector that goes to the motor, and I also know the part number for the connector that goes to control unit (1K0 972 930 A). But I don't know the part number for the connector that goes into the switch. If anyone knows the part number for the connector, that would be very helpful.
 

· Registered
Audi A5 Coupe 1.8 TFSI 2012 Facelift
Joined
·
30 Posts
Discussion Starter · #3 ·
It's a 4 pin connector. It goes here

I found a picture online of all the cables and connectors I (most probably) need, here:

From this picture (from left to right): I know the part number for the first one and the last two. The first one goesinto the control unit, the sixth (black) connector goes to the DC motor of the spoiler. The third is probably ground, but I don't know what the second, fourth and the fifth (adapter) are for.
If it helps, i got some pics here:



I don't have a pic of the other side of the last connector. :/
 

· Registered
Audi A5 Coupe 1.8 TFSI 2012 Facelift
Joined
·
30 Posts
Discussion Starter · #11 ·
Well..Now I have another problem... I bought a almost PnP wiring loom and drove the car to a car electrician. He wired it all up but the spoiler doesn't work. He said I have the wrong ccm.

Does anybody know which ccm I need to have and where can I buy it? And also, please not very expensive haha
 
1 - 9 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top