Joined
·
13 Posts
My Audi Q7 2014 3.0 Sline my mechanic have replaced following , he have already replaced all 6 Spark plugs, replaced 3 Ignition Cools, also got all Fuel Sensors Cleaned and 3 replaced
but Engine Management Sign keep coming back he scanned and found Following Fault Codes
P2006 Intake Manifold Runner Control Bank 1 Stuck Closed
P2007 Intake Manifold Runner Control Bank 2 Stuck Closed
P2237 02 Sensor Positive Current Control CircuitBank 1 Sensor 1Open
P2240 02 Sensor Positive Current Control Circuit Bank 2 Sensor 1
P1129 Open Bank2, mixture adaptation (mult)
System too rich
P112Bank1, mixture adaptation (mult)
System too rich
please guide me to right direction what could be the issue, engine light reappear if while starting it doesn’t start by pressing down Break paddle than have to press Both Gas and Break paddles together, car runs fine after this initial issue, but at times RPM needle just goes up and down like it’s going to cut off engine but than stabilize
but Engine Management Sign keep coming back he scanned and found Following Fault Codes
P2006 Intake Manifold Runner Control Bank 1 Stuck Closed
P2007 Intake Manifold Runner Control Bank 2 Stuck Closed
P2237 02 Sensor Positive Current Control CircuitBank 1 Sensor 1Open
P2240 02 Sensor Positive Current Control Circuit Bank 2 Sensor 1
P1129 Open Bank2, mixture adaptation (mult)
System too rich
P112Bank1, mixture adaptation (mult)
System too rich
please guide me to right direction what could be the issue, engine light reappear if while starting it doesn’t start by pressing down Break paddle than have to press Both Gas and Break paddles together, car runs fine after this initial issue, but at times RPM needle just goes up and down like it’s going to cut off engine but than stabilize